|
Synthesis of the CaAl2O4 nanoceramic compound using high-energy ball milling with subsequent annealing |
January |
2014 |
|
Physical, mechanical and dry sliding wear properties of an Al–Si–Mg–Ni–Cu alloy under different processing conditions |
January |
2014 |
|
The effect of thermomechanical processing on the microstructure and mechanical properties of the nanocrystalline TiNiCo shape memory alloy |
January |
2014 |
|
Formation of the nanocrystalline structurein an equiatomic NiTi shape-memory alloy by thermomechanical processing |
January |
2014 |
|
A study on mechanical and physical properties of monocalcium aluminate cement reinforced with nano-SiO2particles |
February |
2014 |
|
Tribological Behavior of A356/Al2O3 Surface Nanocomposite Prepared by Friction Stir Processing |
January |
2014 |
|
Investigation of the effects of grain size and nano-sized reinforcements on tribological properties of Ti6Al4V alloy |
June |
2013 |
|
Nano-scale grain growth behavior of CoAl intermetallic synthesized by mechanical alloying |
July |
2013 |
|
Tribological behavior of A356/Al2O3 surface nanocomposite prepared by friction stir processing |
December |
2013 |
|
Study on the wear behavior of ultrafine grained 304L stainless steel |
November |
2013 |
|
Development of Al356-Al2O3 nanocomposite coatings by high velocity oxy-fuel technique |
June |
2013 |
|
Properties of bulk Fe-Ni/CNT nanocomposites prepared by mechanical milling and sintering |
July |
2013 |
|
A novel route for development of Al-Cr-O surface nano-composite by friction stir processing |
February |
2013 |
|
Wear characteristics of Al-Cr-O surface nano-composite layer fabricated on Al6061 plate by friction stir processing |
April |
2013 |
|
Synthesis of Cu-Zr-Al/Al2O3 amorphous nanocomposite by mechanical alloying |
September |
2013 |
|
On effect of squeezing pressure on microstructural characteristics, heat treatment response and electrical conductivity of an Al-Si-Mg-Ni-Cu alloy |
September |
2013 |
|
Synthesis of (Fe,Cr)3Al-Al2O3 nanocomposite through mechanochemical combustion reaction induced by ball milling of Cr, Al and Fe2O3 powders |
June |
2013 |
|
The effect of type of atmospheric gas on milling behavior of nanostructured Ti6Al4V alloy |
February |
2012 |
|
Mechanochemical behaviour of NiO-Al-Fe powder mixtures to produce (Ni, Fe)3Al-Al2O3 nanocomposite powder |
June |
2012 |
|
In-situ synthesis of alumina reinforced (Fe,Cr)3Al intermetallic matrix nanocomposite |
November |
2012 |